Delete An Edl; Project Sub-Mode; Enter Project Sub Mode - Datavideo SE-200 Pro Instruction Manual

Move cursor with the left and right arrow keys to the "IN" and "OUT" counter
number positions and enter the updated numbers for the new scene. Then
press the "ENTER" key. The new scene will be inserted into the EDL.
NOTE: The EDL Sub-Mode is for modifying the IN/OUT points of scenes only. To
rearrange the order of scenes, you need to go to Project Sub-Mode (see
below).
Press the "SUB MODE" key to exit EDL Sub Mode and return to the "Editor Mode"
menu.
6.3.6 Delete an EDL: Move the cursor to the "TAPE NO." position in "EDL" sub-mode
and then press the "DELETE" key. The bottom line will appear "Clear this
EDL?(Y/N)" on your TV screen. Press the "Y" or "N" key to answer Yes or No.

6.4 PROJECT SUB-MODE

6.4.1Enter Project Sub-Mode:
Project screen will appear:
SOURCE/TAPE NO.
LAST SEQUENCE NO.
6.4.2 Before you start to assemble a new project, please reset all scenes information
in Project Mode by pressing the "RESET" key to delete all exist scenes which
shown on the screen.
6.4.3 Load a EDL to Porject menu. To start to assemble a new project, please load an
EDL by pressing the "LOAD" key. The following screen will appear:
Press the "4" key to enter Project Sub Mode. The
SEQUENCE
SQ SR SN CAL. DURATION
001
002
003
END: 000, TOTAL LENGTH : 0000000
LOAD EDL FROM
*1.TAPE-1
*2.TAPE-2
*3.TAPE-3
4.TAPE-4
5.EXIT
SCENE NO.
CALIBRATION
SCENE DURATION
TOTAL LENGTH OF PROJECT
31