Editor Mode - Datavideo SE-200 Pro Instruction Manual

programmed into the F15 key, you would press "ALT" + "F5" .
c) To play back any of the effects programmed into Function keys F21-F30,
press "SHIFT" + a Function key. EXAMPLE: to play back the effect
programmed into the F29 key, you would press "SHIFT" + "F9".
d) Once you play back an effect using a Function key, you can play back the
next Function key's effect by pressing the "NEXT" key. EXAMPLE: You just
played back effect F29 by pressing "SHIFT" + "F9" and then "PLAY". To play
back the effect programmed into the F30 key, simply press "NEXT".
e) You can also play back all Fade, Wipe and Animation effects ...(same as
previous item d). For the User-Programmed effect A96, press "ANIMATION",
"96", and then "PLAY".
Note: after playing back one fade/wipe/animation effect (eg. "F23"), you can
play back the next effect (eg. "F24") by pressing the "NEXT" key.
f) You can also play back any Title page by pressing the "T" key, then the Title
page number (eg. "04"), then the "PLAY" key. Note: Title pages will go "in"
automatically but not "out". To make titles go "out", you must press the "PLAY"
key again. After one Title page has been played, you can play the next Title
page in sequence by pressing the "NEXT" key (but again, you must press the
"PLAY" key when you want the Title page to go "out".)
6.0.1
Before proceeding, make sure your recording VCR is properly connected, with
its power on and a blank video tape inserted.
6.0.2
Go to the "Editor Mode" menu by pressing the "MODE" key until the following
screen appears:
6.1 SET UP SUB MODE
6.1.1 Press the "1" key to enter Set Up Sub-Mode.
will appear:

6.0 EDITOR MODE

EDITOR MODE
1. SET UP
2. CUT
3. EDL
4. PROJECT
5. RECORD
20
The Set Up Sub-Mode screen