Specifying Pause Locations Before Embroidering - Brother PR670E Operation Manual

Specifying pause locations before
embroidering
Pause locations can be specified in the pause
setting screen, displayed by touching
a Touch in the embroidering settings
screen.
 The change thread color screen appears.
b From the thread color sequence display,
select the thread color where you wish to
stop the machine before sewing it.
• If the desired thread color is not displayed, use the
scroll bar on the right side to display it.
1
1 Scroll bar
• If the same thread color is used more than once, they
can be combined. After selecting a thread color,
touch . The key changes to
colors in the thread color sequence display that are
the same as the one that was selected are highlighted
in blue.
118
c
.
 The
1
• To cancel the setting, touch
d
• Any number of pauses can be specified.
e
• If the machine is temporarily turned off when it is
, and all thread
Touch .
mark appears to indicate where the machine
will stop.
1
mark
b c
Repeat steps and
you wish to specify.
After specifying the desired settings, touch
.
stopped at the specified location after embroidering,
you will be asked if you wish to continue sewing or
select a new pattern when the machine is turned on
again.
Touch to continue embroidering. (Refer to
"Resume Embroidering After Turning Off the
Machine" on page 101.)
Memo
• If the machine is temporarily turned off, the
settings to stop the machine at color
changes specified before the machine was
turned off are not cancelled. However, the
settings are cancelled if a new pattern is
selected.
• If a pattern with the settings to stop the
machine at color changes is saved, the
settings to stop the machine at color
changes are also saved.
again.
for each pause that