Attaching The Embroidery Frame - Brother PR670E Operation Manual

Attaching the embroidery frame

Adjust the width of the embroidery frame holder to
the size of the embroidery frame, and then attach
the embroidery frame to the machine. As an
example, the procedure for attaching the small
embroidery frame is described below.
1 Left arm of embroidery frame holder
Move the arm of the embroidery frame holder to
the left or right to adjust it to the size of the
embroidery frame.
2 Clip on embroidery frame holder.
Insert the embroidery frame into the clips on the
embroidery frame holder.
3 Positioning pin
4 Holes
5 Positioning slots
a Loosen the two thumb screws on the
embroidery frame holder.
If the screw is too tight, please use the included disc-
shaped screwdriver.
1 Left arm
2 Thumb screws
 The left arm of the embroidery frame holder can be
moved.
• Only loosen the thumb screws a maximum of 2 turns
counterclockwise. Do not remove the screw.
EMBROIDERING TUTORIAL
b Move the left arm to align the screw on the
right side with the mark for the embroidery
frame to be installed, and then tighten the
thumb screws.
For this example, align with mark 4.
1 Mark for extra-large embroidery frame
2 Mark for large embroidery frame
3 Mark for medium embroidery frame
4 Mark for small embroidery frame
5 Align the screw with the mark.
Note
• Please firmly tighten the two thumb screws
with included disc-shaped screwdriver. If
the thumbscrews are not tightened, any of
the following problems may occur.
• The machine will detect the embroidery frame
size incorrectly.
• The starting position for the embroidery frame
is misaligned.
• The embroidery pattern is misaligned.
 The embroidery frame holder is ready for the
embroidery frame to be attached.
c Hold the embroidery frame level, and then
simultaneously align both the left and right
mounts with the embroidery frame holder
clips.
• The inner frame should be on top.
2
45