Table of Contents
Advertisement
WATER
HARDNESS
ENABLE FILTER
ACTIVATE FILTER
WATER
HARDNESS
ENABLE FILTER
ACTIVATE FILTER
WATER
HARDNESS
ENABLE FILTER
ACTIVATE FILTER
SETTINGS
WATER
LANGUAGE
STAND-BY
RESTORE TO DEFAULT
SETTINGS
WATER
LANGUAGE
STAND-BY
RESTORE TO DEFAULT
Under HARDNESS you can set the water hardness level.
For water hardness measuring, refer to the "Measuring and Programming
Water Hardness" chapter.
Under ENABLE FILTER the machine notifi es the user when the water fi lter
needs to be replaced.
OFF: Filter and warning disabled. (Default value) By setting the value
on OFF you disable the fi lter and the replacement warning.
ON: Filter and warning enabled (this warning is automatically set when
the fi lter is activated).
Under ACTIVATE FILTER you activate the fi lter after its installation or
replacement. Refer to the chapter "INTENZA+ Water Filter Installation".
Language Settings
This setting is important to automatically adjust the machine parameters
according to the user's country.
Stand-by Settings
The STAND-BY sets the time lapse for the machine to go into stand-by
mode after last brewing. The stand-by time ranges among 15, 30, 60 and
180 minutes.
The default time value is 30 minutes.
ENGLISH
51
51
Advertisement
Table of Contents
