Stanley STSM1510-B9 Manual page 8

ENGLISH
Specifications
Capacity of cut
47° mitre left and right
47° bevel left
0° mitre -Max. Height 3-1/2" -Max. Width 5-1/2"
45° mitre -Max. Height 3-1/2" -Max. Width 4-1/8"
45° bevel -Max. Height 2-1/2" -Max. Width 5-1/2"
Bench Mounting
Bench mounting holes (8) are provided in all four feet to
facilitate bench mounting, as shown in Figure 1. (Two
different sized holes are provided to accommodate different
sizes of screws. Use either hole, it is not necessary to use
both.) Always mount your saw firmly to prevent movement.
To enhance the tool's portability, it can be mounted to a
piece of 1/2" or thicker plywood which can then be clamped
to your work support or moved to other job sites and
reclamped.
NOTE: If you elect to mount your saw to a piece of plywood,
make sure that the mounting screws don't protrude from the
bottom of the wood. The plywood must sit flush on the work
support. When clamping the saw to any work surface, clamp
only on the clamping bosses where the mounting screw
holes are located. Clamping at any other point will interfere
with the proper operation of the saw.
CAUTION: To prevent binding and inaccuracy, be
sure the mounting surface is not warped or
otherwise uneven. If the saw rocks on the surface, place a
thin piece of material under one saw foot until the saw sits
firmly on the mounting surface.
Installing a New Saw Blade
(UNPLUG THE MITRE SAW)
DO NOT USE FERROUS METAL or masonry cutting blades
in this saw
• Loosen hex bolt on center cover counter clockwise with
box wrench.
• Lift up the safe cover and center cover.
8
(Original instructions)
•
•
•
Note: There are two different internal diameters of cutter in
inner plate which have steel stamp marked 25.4mm 16mm.
When mounting, the outer diameter of inner plate must be
correspondent with the internal diameter of saw blade.
•
•
Note: Only use attached wrench when mounting or
dismounting saw blade. When dismounting saw blade, lift up
safe cover and centre cover. Loosen hex bolt with box
wrench and disassemble hex bolt, flange and saw blade.
NEVER DEPRESS THE SPINDLE LOCK PIN WHILE THE
BLADE IS ROTATING.
•
Assembling and Adjusting Your Saw
PERFORM ALL ASSEMBLY WITH SAW UNPLUGGED.
Attach Mitre Clamp Handle
Remove the mitre clamp handle (4) from the plastic parts
bag and carefully thread it into the bracket in the front of the
saw.
Attaching Dust Bag
A zippered cloth dust bag is included with your saw. To
attach the bag, fit the plastic opening firmly over the dust
spout (9).
NOTE: The saw can also be used with a vacuum cleaner
hose attached to the dust spout or without any attachment.
Adjustments
PERFORM ALL ADJUSTMENTS WITH THE MITRE SAW
UNPLUGGED
NOTE: Your mitre saw is fully and accurately adjusted at the
factory at the time of manufacture. If readjustment due to
shipping and handling or any other reason is required, follow
the steps below to adjust your saw.
Press down the lock to lock spindle.
Loosen hex bolt clockwise with box wrench, then
dismount the bolt and flange.
Mount the blade of saw on spindle. Make sure that the
arrow direction on surface of saw blade is same as one
of the cover.
Mount flange and hex bolt.
Press axle lock and tighten hex bolt counter clock wise
with box wrench firmly, then tighten hex bolt clockwise to
fix centre cover.
Be sure to hold the guard bracket down and firmly
tighten the guard bracket screw when you finish installing
the saw blade. Failure to do so will cause serious
damage to the saw.