Table of Contents
Advertisement
Perform the settings relating to the motion detection
The settings relating to the motion detection are performed as follows: Up to 2 detection areas can be set.
Follow the procedure below.
"CAMERA SETUP" screen
**CAMERA SETUP**
SCENE1
ALC/ELC
ALC
SHUTTER
OFF
AGC
ON(HIGH)
SENS UP
OFF
WHITE BAL
ATW
1
DNR
HIGH
BW MODE
OFF
VMD
RET TOP END
Step1
Move the cursor to "VMD" and press the setting button.
→ The "VMD SETUP" screen appears.
Step2
Move the cursor to "MOTION DET" and perform the setting.
ON: Provides an alarm signal when motion is detected.
OFF (default): Disables the motion detection.
Step3
Move the cursor to "AREA" and select a detection area.
ALL (default): All areas are selected for detection.
SETUP: Up to 2 areas can be selected for detection after selection of "SETUP" and pressing the setting button. Refer to page 16 for
how to set the detection area.
Step4
Move the cursor to "SENSITIVITY" and select the detection sensitivity from the following:
LOW (default)/MID/HIGH
Step5
Move the cursor to "DISPLAY MODE" and press the setting button.
→ The demonstration mode is conducted, and the blocks in which a motion is detected are shown in white.
"VMD SETUP" screen
**VMD SETUP**
MOTION DET
ON
AREA
SETUP
SENSITIVITY
LOW
DISPLAY MODE
SCENE CHANGE
OFF
RET TOP END
Block in which a motion is detected
Area setting screen
**AREA 1 /2**(1)
POSITION
PUSH SW
UPPER LEFT
DEL
RET TOP END
15
Advertisement
Table of Contents
