Basic Operations - Panasonic AW-UE70WP Operating Instructions Manual

Basic operations

Camera menus are displayed on the monitor when the unit's
settings are to be selected.
The monitor is connected to the video signal output
connector.
The basic camera menu operations involve displaying
sub-menus from the Top Menu items, and selecting settings
on the sub-menus.
Some sub-menus have menu items for performing more
detailed settings.
The camera menu operations are conducted using the
wireless remote control.
If a controller is connected, they can also be conducted using
the controller.
Note
● Check that your controller is the following version.
AW-RP50: Ver 3.20.00 or later
AW-RP120: Ver 2.30.00 or later
AK-HRP200: Ver 5.10-00-0.00 or later
If the version older, an upgrade is required.
For details on upgrading, visit the support page on the
following website.
http://pro-av.panasonic.net/
Described below are the basic operations for changing the
camera menu item settings using the wireless remote control
and controller (AW-RP50, AW-RP120 or AK-HRP200).
Table of operations
Camera menu operation
Selecting the unit to be
Press the [CAM1], [CAM2], [CAM3]
operated or [CAM4] button.
Press the [MENU] button for
Displaying the Top Menu
2 seconds.
Press the [▲] or [▼] ([◄] or [►])
Selecting the items
button.
Displaying the
Press the [
sub‑menus
Returning to the
With the cursor at the "Return"
previous menu
position, press the [
With the cursor at the item to be
changed, press the [
start the item's value blinking.
Changing the settings
Use the [▲], [▼], [◄] and [►]
buttons to change the value, and
press the [
change.
While the setting is blinking, press
Canceling the setting
the [MENU] button quickly (for less
change
than 2 seconds).
22
Wireless remote control
○
] button.
○
] button.
○
] button to
○
] button to enter the
Only the steps taken using the wireless remote
control will be described here for the operations
conducted to select and set the items.
For details of the operations conducted using the
controller, substitute "controller" for "wireless
remote control" when reading the basic operations.
Also, refer to the Operating Instructions of the
controller.
AW‑RP50 AW‑RP120
Press one of the [CAMERA
STATUS/SELECTION] buttons.
Press the [CAMERA OSD] button for
2 seconds.
Turn the F1 dial.
Press the F1 dial.
With the cursor at the "Return"
position, press the F1 dial.
1. Press the F1 dial to start the
setting blinking.
2. Turn the F1 dial to change the
setting.
3. Press the F1 dial to enter the
setting (and stop the blinking).
—
Controller
AK‑HRP200
1. Press and hold the [SELECT]
button for about 2 seconds.
 The camera number in the
camera number display area
blinks.
2. Press the lit [UP]/[DOWN] button.
 Press the lit [UP]/[DOWN]
button to select the camera
number.
3. Press the [SELECT] button.
 Control of the selected camera
is enabled.
Press and hold the [CHARA/MENU]
button for about 2 seconds.
Turn the SELECT dial.
Press the SELECT dial.
With the cursor at the "Return"
position, press the SELECT dial.
1. Press the SELECT dial to start
the setting blinking.
2. Turn the SELECT dial to change
the setting.
3. Press the SELECT dial to
enter the setting (and stop the
blinking).
—