Led Indication; Configuring Ip Address And Password For The Switch - KTI Networks KGS-510F-C Installation Manual

2.8 LED Indication

LED Function
POWER Power status
LNK/1000M/ACT Port link status
LNK/100M/ACT Port link status
LNK/10M/ACT Port link status
P6 LNK Port6 link status
P6 OL Port6 optical link ON

2.9 Configuring IP Address and Password for the Switch

The switch is shipped with the following factory default settings for software management :
Default
IP address of the switch : 192.168.0.2 / 255.255.255.0
The IP Address is an identification of the switch in a TCP/IP network. Each switch should be desig-
nated a new and unique IP address in the network. Refer to Web management interface for System
Configuration.
The switch is shipped with factory default password 123 for software management.
The password is used for authentication in accessing to the switch via Http web-based interface. For
security reason, it is recommended to change the default settings for the switch before deploying it to
your network. Refer to Web management interface for System Configuration.
State Interpretation
ON The power is supplied to the switch.
OFF The power is not supplied to the switch.
ON A 1000M link is established. (No traffic)
BLINK Port link is up and there is traffic.
OFF Port link is down.
ON A 100M link is established. (No traffic)
BLINK Port link is up and there is traffic.
OFF Port link is down.
ON A 10M link is established. (No traffic)
BLINK Port link is up and there is traffic.
OFF Port link is down.
ON A 1000M link is established on Port 6.
BLINK Port 6 link is up and there is traffic.
OFF Port 6 link is down.
Optical signal is detected on Port 6.
OFF No optical signal is detected on Port 6.
-14-