U-Line Wine Captain 1000 Series User Manual & Service Manual page 15

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
6. Secure integrated panel to
door/drawer using
clamps. A robust tape
may also be used. U-Line
recommends the use of
bar clamps to
Door/Drawer
secure the panel to
the door/drawer. If
Wood
Panel
using tape, be
certain the tape will not
damage panel finish upon
removal.
7. Using a 7/64" (3 mm) drill
bit, drill 6 pilot holes into
the wood panel 1/2" (12
mm) deep using the holes
in the door/drawer frame as a guide.
NOTICE
It is important to ensure that all drilled holes are
drilled to the correct depth in order to avoid
splits in the wood when hardwood is installed.
11.Remove clamps from door/drawer.
NOTICE
If panel requires additional adjustment after
removing clamps, slightly loosen each screw and
adjust panel as necessary. Tighten screws upon
completion.
12.Starting at the corners, re-install the gasket into the
gasket channel in the frame. Make sure the gasket is
fully seated. This may take some force.
8. Locate 6 of the #6x 1-1/4" (32 mm) screws
provided with your unit.
9. Using a Phillips screwdriver, place one screw into
each of the 6 pilot holes and screw down. Do not
overtighten screws.
10.Be sure the screws force their way past the opening
on the gasket channel and sit flush against the
bottom of the channel.
Integrated Panel
u-line.com
Integrated Panel
Integrated Panel Installation 1