Table of Contents
Advertisement
10.
After making your selection press <Enter>.
11.
In the BIOS SETUP UTILITY select the Exit Menu.
12.
Select Save Changes and Exit and press <Enter> to exit the BIOS
System Setup utility.
Note
If your system behaves abnormally after changing BIOS settings, enter BIOS,
select the Exit menu and select Load BIOS default settings. Then select
Save Changes and Exit to return BIOS to the default settings.
5.2 Hard Disk Recovery
In case of system failure, Windows Vista® can be recovered to the hard disk
by running the hard disk recovery utility. Before starting this utility, make
sure to back up important data and files.
To run the hard disk recovery utility
1.
Shut down the Mobile Computer and then power it on again.
2.
At the start of the boot-up process, immediately press F3 to run the
hard disk recovery utility.
3.
You will then see the following screen:
Recovery process is starting .....
The process will delete all data on the hard drive.
Do you want to terminate the process? (Y/N)
Press N to continue with the hard disk recovery process. If you press Y,
the hard disk recovery utility is terminated.
4.
The next message prompts you whether or not to rebuild the MBR
(Master Boot Record) data:
Recovery process is starting .....
The process will delete all data on the hard drive.
Do you want to terminate the process? (Y/N)
Do you want to rebuild the MBR (Master Boot Record) data? (Y/N)
Securing and Managing the Mobile Computer 101
N
Advertisement
Table of Contents
