Using The Needle Threader - Janome AT2000D Instruction Book

z
x
w
c
L
v
r
b
t
n
r
m
q
e
R
y
u

Using the needle threader

Following the procedure m on page 29 or page 32,
thread the needles with the needle threader shown
below.
CAUTION
Turn the power switch OFF before threading the
machine.
z Turn the handwheel toward you to match the "o" mark
on the belt cover with the "-" mark on the handwheel.
q Handwheel
x Lower the presser foot lifter.
w Presser foot lifter
c Set the needle threader switch lever to R when
threading the right needle.
Set the needle threader switch lever to L when
threading the left needle.
e Needle threader switch lever
v Pull down the needle threader lever as far as it will go.
r Needle threader lever
b Draw the thread along the guide on the needle
threader switch lever from the left and under the hook.
t Guide
y Hook
* Make sure that the thread or your finger does not
touch the upper looper or the upper knife.
n Slowly raise the threader lever so that a loop of the
thread is pulled up through the needle.
r Needle threader lever
u Loop
m Pull the thread loop and draw out the thread end to
the rear through the needle eye.
30