Switching on the
appliance
1. First insert the plug into the
connection on the back of the
appliance. Check that the plug has
been inserted all the way.
2. Then insert the other end of the cable
into the socket.
The appliance is now switched on and a
warning signal sounds.
Press the °C button to switch off the
audible warning signal.
The alarm display goes out when the
appliance has reached the set
temperature.
The preset temperatures are reached
after several hours. Do not put any food
in the appliance beforehand.
The factory has recommended the
following temperatures:
freezer compartment: -18°C
■
hyperFresh compartment: 0 °C to
■
2 °C
cooling compartment: +4°C
■
Operating tips
When the appliance has been
■
switched on, it may take several hours
until the set temperatures have been
reached.
The fully automatic NoFrost system
■
ensures that the freezer compartment
remains free of ice. Defrosting is no
longer required.
The sides of the housing are
■
sometimes heated slightly. This
prevents condensation in the area of
the door seal.
If the freezer compartment door
■
cannot be immediately re-opened after
it has been closed, wait until the
resulting low pressure has equalised.
Setting
the temperature
Fig. $
Refrigerator compartment
The temperature can be set from +2 °C
to +8 °C.
1. Press selection button 13 until
refrigerator compartment display 1 is
activated.
2. Keep pressing +/– buttons 11 until
the required temperature is indicated.
Perishable food should not be stored
above +4 °C.
hyperFresh compartment
The temperature can be set from -1°C to
3°C.
1. Press selection button 13 until
hyperFresh 3 display is activated.
2. Keep pressing +/- buttons until the
required temperature is indicated.
en
11