Table of Contents
Advertisement
F2450
Installing Outside Air from Pedestal Base
If installing outside air from pedestal base, do not remove knock
out from rear of pedestal. This must remain in place.
10. Secure collar to base of unit with 4 screws.
075-500.SLDASM
11. Install bottom metal cover over collar installed in step 10 and
rest cover on pedestal base.
12. Secure flex to collar with supplied screws or the 4" clamp.
13. Bring pedestal base near the base of the firebox and secure flex
to mobile home box with supplied screws.
14. Secure Mobile Home Box and pedestal to the firebox base
using the screws that were previously removed in step 1. See
pedestal instructions.
15. Install blanking plate to the front of the pedestal with 4 screws.
Use picture from step 8.
16. Install the mandatory outside air kit. See «Mobile Home Instal-
lation» section in this manual. Place unit into its final position
to complete install.
920-167
Mobile Home Box
Flex
Bottom Metal Cover
Collar
Page 1 of 1
Pedestal Base
Installing Outside Air Using Bottom Heat
Blanking plate
Knock out
17. Remove knock out from the bottom heat shield and bend tabs left
over when the knock out was removed to the side.
18. Secure collar to base of bottom heat shield as shown with 4 screws.
19. Secure transition box on top of round collar installed in step 18
and secure with 3 screws.
20. Install blanking plate if not already installed.
21. Secure Mobile Home Box and bottom heat shield. See bottom
12/19/2016
heat shield/leg instructions.
22. Install the mandatory outside air kit. See «Mobile Home Instal-
lation» section in this manual. Place unit into its final position to
complete install.
F2450M Regency Freestanding Woodstove
installation
Shield/Legs
Mobile Home Box
Square Transition Box
Collar
Bottom Heat Shield
Cast legs
075-500.SLDASM
12/19/2016
|
17
12.10.19
Advertisement
Table of Contents
