Safety Screen & Door Removal / Installation - Napoleon XIR4 Installation And Operating Instructions Manual

12
4.2 SAFETY SCREEN & DOOR REMOVAL / INSTALLATION
EN
IF EQUIPPED WITH DOOR LATCHES THAT ARE PART OF A SAFETY RELIEF SYSTEM, THEY MUST BE
PROPERLY ENGAGED. DO NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and shall be installed.
Before the glass door can be removed, the safety screen must be removed. Lift the safety screen off the 4
side pins and remove from the appliance.
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
There are 2 latches on the top of each door.
A.
Using the tool provided, pull the latch forward and upwards, out of the slot in the door, as shown.
B.
Ensure to keep one hand on the door at all times, to prevent it from falling on the floor.
When both latches have been released tilt the door forward and out of the bottom door retainer.
C.
Reverse these steps to re-install the safety screen and door. Ensure safety screen is installed
D.
correctly.
W415-1344 / A / 12.14.16
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
THIS WARNING FOR ELECTRICS ONLY:
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
WARNING
!
WARNING
!
75.1A
75.1