Editing A Patch - Zoom G1N Operation Manual

Editing a Patch (Edit Mode)
The patches of the G1N/G1XN can be freely edited by changing the effect type used by the
various modules and by changing the parameter settings. Try editing the currently selected patch to
create your own sound.
1
Select the effect module/parameter
Turn the Module selector to select the effect module
and parameter to edit. The available settings are
listed below.
(1) PATCH LEVEL (Prm)
(2) COMP/EFX module (Type&Prm)
(3) DRIVE module (Type)
(4) DRIVE module (Prm)
(5) – (7) EQ module (Prm)
(8) ZNR/AMP module (Type&Prm)
(9) MODULATION module (Type&Prm1)
(10) MODULATION module (Prm2)
(11) DELAY module (Type&Prm1)
(12) DELAY module (Prm2)
(13) REVERB module (Type&Prm1)
(14) REVERB module (Prm2)
The "Type" and "Prm" indication in brackets
indicates the item category.
• Type&Prm or Type&Prm1 (Type & Parameter)
Item where the effect type (left side of display) and
parameter setting value (right side of display) are
adjusted simultaneously.
• Type
Item where the effect type only is selected.
• Prm or Prm2 (Parameter)
Item where the parameter setting value only is
adjusted.
14
(6) (7)
(8)
(5)
(9)
(4)
(3) (10)
(11)
(2)
(12)
(1)
(13)
(14)
The EQ module has three
parameters, and the
MODULATION, DELAY, and
REVERB modules have two
parameters each.
Switching the type gives
access to the second and
third parameter.
C1 C1
C1
Parameter Parameter
Parameter
setting value
setting value setting value
Effect type
Effect type Effect type
FD FD FD
Effect type
Effect type Effect type
25 25 25
Parameter setting value
Parameter setting value Parameter setting value
ZOOM G1N/G1XN
2
Change the setting
Turn the [VALUE] knob.
The setting of the selected item changes, and a dot (
appears in the bottom right of the display. This
indicates that a setting has been changed from the
currently stored value.
When you have selected a parameter that can be set
HINT
with the tap function ( g p. 21), you can repeatedly hit
the [BANK UP·TAP] key at the desired interval to
specify the timing.
3
To switch an effect module on and off
Press one of the [ ]/[ ] foot switches.
W Q
The indication "oF" appears on the display and the
module is turned off. Pressing one of the switches
once more returns the setting to the previous
condition.
4
Terminate the edit mode
Set the Module selector to the "PLAY" position to
return to the play mode.
When you return to play mode and have made any
NOTE
changes to the patch, the dot (.) will be shown in the
bottom right of the display. If you select another patch
in this condition, the changes you have made in edit
mode will be lost unless you store the patch first. To
retain the changes, store the patch as described on page
16.
ZOOM G1N/G1XN
Editing a Patch (Edit Mode)
.
)
C2
Dot indicates that setting
has been changed
OF
15