Editing A Patch - Zoom B1 Operation Manual

Editing a Patch

The patches of the B1/B1X can be freely edited by changing the effect parameter settings. Try editing the
currently selected patch to create your own sound.
Select the effect module/
parameter
Turn the Module selector to select the
effect module and parameter to edit. The
available settings are listed below.
The EQ module has three parameters, and the DRIVE,
MODULATION/DELAY, and REVERB/DELAY
modules have two parameters each. The Module
selector lets you directly access each of these.
(6) (7)
(8)
(5)
(4) (9)
(3)
(2)
(1)
(14)
Type = Effect type Prm = Parameter
(1) Patch level (Prm)
(2) COMP/LIMIT module (Type&Prm)
(3) EFX module (Type&Prm)
(4) DRIVE module (Type)
(5) DRIVE module (Prm1)
(6) DRIVE module (Prm2)
(7) – (9) EQ module (Prm)
(10) ZNR/AMP module (Type&Prm)
(11) MODULATION/DELAY module (Type&Prm1)
(12) MODULATION/DELAY module (Prm2)
(13) REVERB/DELAY module (Type&Prm1)
(14) REVERB/DELAY module (Prm2)
Type&Prm or Type&Prm1
Item where the effect type (left
side of display) and parameter
setting value (right side of display)
are adjusted simultaneously.
C 1
Effect type Parameter
setting value
12
(10)
(11)
(12)
(13)
Type Prm, Prm1, or Prm2
Item where the effect Item where the
type only is selected. parameter setting
value only is adjusted.
A G 2 5
Effect type Parameter setting value
ZOOM B1/B1X
Change the setting
Use the [VALUE] knob to change the effect
type and parameter as shown on the
display.
When the effect type and/or parameter setting has
been changed, a dot (.) appears in the bottom right of
the display. This indicates that a setting has been
changed.
NOTE
To switch an effect module
on and off
To switch the currently selected effect
module between on and off, press one of
the [W]/[Q] foot switches.
The indication "oF" appears on the
display. When you press one of the
switches once more, the indication returns
to the previous condition.
Terminate the edit mode
To terminate the edit mode and return to the play
mode, set the Module selector to the "PLAY" position.
NOTE
When you return to play mode and have made any
change to the patch, the dot (.) will be shown in the
bottom right of the display. If you select another patch in
this condition, the changes you have made in edit mode
will be lost unless you store the patch first. To retain the
changes, store the patch as described on page 14.
ZOOM B1/B1X
Editing a Patch
C 2
Dot indicates that setting
has been changed
When you have selected a parameter that
can be set with the tap function (→ p. 18),
you can use the [BANK UP•TAP] key to
specify a time interval or rate by repeatedly
hitting the key.
O F
13