NEC NC2041L User Manual page 23

10. ENTER button
Press this button to select the menu item.
11. EXIT button
Press this button to return to the previous menu item.
12. KEY LOCK button
Press this button to lock (KEY LOCK) the buttons on the control panel. Buttons on the control panel do not function while KEY
LOCK is on.
Pressing the KEY LOCK button for one second or longer while KEY LOCK is off locks the buttons.
Pressing the KEY LOCK button for one second or longer while KEY LOCK is on unlocks the buttons. (See page 40)
KEY LOCK becomes automatically on if no control panel operation takes place in the standby state for 30 seconds
NOTE
by default. (See page 40)
13. POWER button
Press this button for more than three seconds to turn on or off (standby) the projector. (See page 68)
In order to start up the projector, turn on the projector power switch and light power switch for the projector to set the projector
in the standby state. (See page 32)
14. DOUSER button
Press this button to open and close the douser. (See page 67)
15. LIGHT ON/OFF button
Press this button for three seconds or longer to turn on or off the light source while the projector is on. (See page 41)
16. LIGHT ADJ button
Press this button to display the light source adjustment menu. (See page 39)
17. IMB button (planned to be supported in a future update)
This button is operable when the media block is installed in the projector.
Press this button to display the operation menu of the media block.
18. SERVICE button
This button is used for service purpose only.
19. Stop button (planned to be supported in a future update)
This button is operable when the media block is installed in the projector.
Press this button to stop playing the image contents.
20. Play/pause button (planned to be supported in a future update)
This button is operable when the media block is installed in the projector.
Press this button to play or pause the image contents.
21. Preset buttons
Press the preset button to select a title (input signal) assigned to each button. Up to 100 titles (input signals) can be registered
to this projector, and any 20 titles from them can be assigned to the preset button. Please request your dealer to register and
change the titles of the buttons as required.
The preset button indicators show their assigned title or selection status. (See page 67)
TIP
To select a title allocated to one of the preset buttons, use the following procedure.
• T o select a title allocated to one of "Preset Button1" to "Preset Button10"
Press the button which corresponds to the number of the preset button (button <1> to <10>).
- Press the <1> button to select the "Preset Button1".
- Press the <10> button to select the "Preset Button10".
• T o select a title allocated to one of "Preset Button11" to "Preset Button20"
Press the preset button (button <1> to <10>) while holding down the UP button.
- Press the <1> button while holding down the UP button to select the "Preset Button11".
- Press the <10> button while holding down the UP button to select the "Preset Button20".
1. What's in the Box? and the Names of the Projector Parts
23