Table of Contents
Advertisement
1. What's in the Box? and the Names of the Projector Parts
8. Remote interlock connector (inside side of projector)
This port is for safely using this device. It is used to externally control the projector.
Consult with your dealer/distributor about using this.
9. Connection terminals
Various image signal cable are to be connected here. (See page 21)
You can expand signal input terminals by installing the optional board. (See page 21)
Contact your dealer/distributor for more information on separately sold optional products.
10. AC input
Connects to the AC power cable. The AC power cable is not an accessory. Consult with your dealer/distributor about the AC
power cable.
11. Power cable stopper
Prevents the power plug from falling out from the projector.
12. Projector power switch
While AC power is being supplied, set the projector power switch and light power switch to ON position, then your projector will
enter a standby state.
13. Air inlet / Air filter
The air inlet for cooling inside the projector. Do not cover.
An air filter is attached over the air inlet to prevent dust. Refer to "5-3. Cleaning the Air Filters" (page 58) on how to clean the
air filter.
14. Lens (optional)
Images are projected from the lens. Request your dealer/distributor to install or replace the lens.
Do not cover the air inlets and outlet while the projector is in operation. Insufficient ventilation leads to a rise of the
NOTE
internal temperature and may cause a fire or malfunction.
18
Advertisement
Table of Contents
