Table of Contents
Advertisement
DO
AND
HOST FORMS DESCRIPTION LANGUAGE 3.2 FOR IBM MVS CREATING FORMS
Figure 3–20.
name
SECTION
C
y
,
units
REPEAT
HORIZONTALLY
VERTICALLY
Parameters
name specifies the name of the section you want to invoke.
n TIMES specifies the number of times you want the section
repeated.
specifies the y –axis where you want the section origin
C
y
located.
C
specifies the x –axis where you want the section origin located.
x
units indicates the unit of measure for placement of the section
origin. The units are INCHES, CENTIMETERS, DOTS, and
XDOTS. You can use two decimal places when you specify
inches and centimeters. You must express DOTS and XDOTS in
integers.
REPEAT specifies the number of times you want a section
repeated in the orientation you specified.
HORIZONTALLY or VERTICALLY specifies the orientation of the
lines you want repeated.
EVERY C
increment you have specified.
AT C
indicates that you want to repeat the section at the
a
absolute coordinate you have specified.
Default
VERTICALLY, if you specified REPEAT.
Examples
Long form:
DO SECTION NUSEC 3 TIMES AT 1,1 AND REPEAT
HORIZONTALLY EVERY 4;
Short form:
DO NUSEC 3 AT 1,1 REPEAT HORIZONTALLY EVERY 4;
DO SECTION command syntax
n
TIMES
C
x
units
EVERY
AT
indicates that you want to repeat a section at the
i
USING HFDL COMMANDS
AT
C
i
units
C
a
units
,
;
3–29
Advertisement
Table of Contents
