How To Remove Panels - Hoshizaki F-1001MAJ-C Instruction Manual

• Remove the protective plastic film from the panels. If the appliance is exposed to the
sun or to heat, remove the film after the appliance cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• Flaker models can be installed on an ice storage bin only. Cubelet models can be
installed on either a dispenser unit or an ice storage bin. The ice storage bins listed
below are recommended.
Model Number Bin Width
F-450MAH(-C)
F-801M_H(-C)
F-1001M_J(-C)
For further options, contact your local Hoshizaki distributor.
• NOTICE! Remote models must be connected to an appropriate remote condenser
unit. The remote condenser units listed below are recommended. Connection to a
different remote condenser unit will void the warranty unless Hoshizaki approves
a different remote condenser unit for your specific application. For further
details, contact your local Hoshizaki distributor.
Model Number
F-1001MRJ(-C)
• On low-side models, an R-404A parallel rack system is needed. See "II.H. Connection
to an R-404A Parallel Rack System" for refrigeration circuit details.
C. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and
towards you.
• Top Panel: Lift up at front slightly, push rearward
and lift off.
• Side Panels: Remove the screw. Slide forward
slightly and lift off.
Recommended Hoshizaki Ice Storage Bin
22" or Wider B-300 Series
Recommended Hoshizaki Remote Condenser Unit
URC-5F
Side Panel
Front Panel
Model Shown: F-1001MAJ-C
14
Top Panel
Side Panel
Fig. 1