GE WSLS1500HWW Owner's Manual & Installation Instructions page 17

WASHER CONNECTIONS - STATIONARY MODEL WSLS1500
INSTALLATION CHECKLIST
6
Before starting the washer, check to make sure:
Main power is turned on.
The washer is plugged in.
The water faucets are turned on.
The unit is level.
The drain hose is properly tied up.
There are no leaks at the faucet, drain line
or washer.
RUN THE WASHER THROUGH A
7
COMPLETE CYCLE
Check for water leaks and proper operation.
ALCOVE OR CLOSET INSTALLATION
• Minimum clearances between washer and adjacent
walls or other surfaces are: 1" top, 1" either side,
2" front (closet only) and 4" rear.
• Consideration must be given to provide adequate
clearance for installation and service.
• Closet doors must be louvered or otherwise ventilated
and have at least 60 square inches of open area. If the
closet contains both a washer and a dryer, doors must
contain a minimum of 120 square inches of open area.
Installation Instructions
17
REMOVE THE PROTECTIVE FILM
8
COVERING THE CONTROL PANEL
READ THE REST OF THIS OWNER'S
9
MANUAL
It contains valuable and helpful information that will
save you time and money.
NOTE: If your washer does not operate, please
review the Before You Call For Service section.
Closet door
60 sq. in.
(387.1 sq. cm)
60 sq. in.
(387.1 sq. cm)