GE WSLS1500HWW Owner's Manual & Installation Instructions page 12

Care and cleaning.
Housing
Filter
Housing
rails
Filter
guide
rib
12
Exterior of the Washer
Immediately wipe off any spills. Wipe with damp
cloth. Try not to hit surface with sharp objects.
Pump Filter and Housing
Clean EVERY MONTH to remove any items
that may have been caught in the filter or
housing.
1. At the bottom back of the washer, place
a towel or shallow pan on the floor under
the filter cap to catch any water that may
flow out.
2. Turn the filter cap counter-clockwise and
pull to remove. Water may begin to flow
out.
3. Remove any objects and lint from the
housing and filter.
4. Replace the filter by aligning its guide rib
with the housing rails, pushing all the way
in and turning clockwise to lock in place.
Inlet Water Valve Screen(s)
If the flow of entering water into the washer
is slow, the inlet water valve screen(s) may be
clogged.
Check and clean inlet valve screens EVERY
SIX MONTHS.
1. Turn off water valve(s).
2. Disconnect water hose(s) from the back of
the washer.
3. Remove the screen(s), clean with a brush
and replace.
Water Supply Hoses
Hoses connecting washer to faucet should be
replaced every 5 years.
Moving and Storage
Ask the service technician to remove water from
drain pump and hoses. Do not store the washer
where it will be exposed to the weather.
Long Vacations
Be sure water supply is shut off at faucets. Drain
all water from hoses and water filter pump area
if weather will be below freezing.
Back
Clean EVERY MONTH to remove
any items that may have been
caught in the filter or housing.
4. Replace the hose(s).
5. Turn water valves on.
6. Check for leaks, tighten if necessary.