Table of Contents
Advertisement
Step 5: Connect and Configure Options
When there are optional PCI boards or peripheral devices to connect to the main unit, power off the
main unit. Then, for connecting them, follow the instructions in "PCI board" in the separate volume
of the User's Guide and the manual of the devices.
Make dual configuration when you added LAN and disks. For details, see "Step 8 Set Duplex LAN
Configuration" and "Step 9 Set Dual Disk Configuration".
Step 6: Update Software
If you use ftServer Control Software UPDATE Disc (CD-ROM or DVD-ROM), refer to the
installation procedure enclosed in the UPDATE Disc to apply the update. When there are other
update modules, apply them in this step.
Step 7: Windows Server 2008 / Windows Server 2003 Service
Pack Installation
Installing Windows Server 2008 / Windows Server 2003 Service Pack
A Service Pack for Windows Server 2008 and Windows Server 2003 is not applied to the system
immediately after Windows install and re-install.
Refer to "Applying Windows Service Pack" on page 5-16, and apply Windows Server 2008 and
Windows Server 2003 Service Pack.
IMPORTANT:
The Service Pack 2 for Windows Server 2008 or Windows Server 2003 must be installed
on the NEC Express5800/ft server.
There is no Hot Fix when this User's Guide is issued. Contact your sales representative
for the latest Service pack or the Hot Fix.
If you install the Recovery Console on "Step 13: Make Settings for Failure
Management.", first install the Recovery Console, and then apply Windows Server 2003
Service Pack 2.
Windows Setup 4-53
Advertisement
Table of Contents
Troubleshooting
