Sony HDCU2580 Operation Manual page 38

CCU
CONFIGURATION
Page name
Page No.
<SPIRIT LEVEL>
C21
(Available only when a
serial lens is attached to
the HDC2580 HD Color
Camera.)
<BOARD SETUP>
C22
<OTHERS>
C23
NETWORK SETTINGS menu
NETWORK SETTINGS
Page name
Page No.
<IP ADDR SET>
N01
38
Setup Menu
Item Settings
INDICATOR OFF, ON, ---
REVERSE OFF, ON
H POSITION 0 to 99, 50
V POSITION 0 to 99, 50
BOARD SELECT DRX1, DRX2, DRX3, RC
EMBED AUDIO ON, OFF
META DATA OFF, ON
EMBED
PAYLOAD ID LATEST, 2002, 2010, 2011
INTER LOCK OFF, ON
ASSIGNABLE NONE, BARS, CLEAN, CAM
POWER, FORCE LEGACY, REF
LOCAL HD, REF LOCAL SD
CCU NO 0, 0 to 96, A to Z
SYNC OUT SD SYNC, HD SYNC
CAM MENU OFF, ON
Item Settings
HOST IP ADDRESS 0.0.0.0 to 255.255.255.255
SUB NET MASK 0.0.0.0 to 255.255.255.254
DEFAULT GATEWAY 0.0.0.0 to 255.255.255.255
SET
Description
Turns the spirit level display on/off.
OFF: Moves to the tilted direction.
ON: Moves to the reverse direction of the tilted
direction.
Adjusts the horizontal position.
Adjusts the vertical position.
Selects the board to set.
DRX1 to 3: Only when an HKCU2007 board is
installed.
Sets superimposition of audio data to ON/OFF.
Sets superimposition of metadata to ON/OFF.
Sets the PAYLOAD ID of VIDEO.
SDI output (3, 4) format linking function
Sets the function for the assignable button.
NONE: No assignment.
BARS: Sets the color bar output to ON/OFF.
CLEAN: Sets character superimposition for all
output slots to ON/OFF.
CAM POWER: Sets camera power to ON/OFF.
FORCE LEGACY: Forces the communication mode
to LEGACY mode.
REF LOCAL HD: Sets GENLOCK to LOCAL HD.
REF LOCAL SD: Sets GENLOCK to LOCAL SD.
Sets the CCU number.
Sets the SYNC OUT connector.
Displays the Camera menu.
Notes
• If CAM MENU is set to ON, CCU
CONFIGURATION menu operations cannot be
performed because only Camera menu operations
are available.
• The Camera menu is not displayed when SD
signal is output.
Description
Displays the IP address.
Displays the subnet mask.
Displays the default gateway.
A "SET OK?" message is displayed. Press ENTER
again to confirm the change. (Execute via ENTER.)