Removable Module Operation In Non-Redundant (Standalone) Applications; Figure 4-17. Dt-4500 Standalone Cabling Example To Iom; Figure 4-18. Dt-4500 Standalone Cabling Example To Rsm - Comtech EF Data DT-4500 Series Installation And Operation Manual

DT-4500 Series C- and Ku-Band Down Converters
Front and Rear Panel Connectors
The 'J3 | HSB' connector does not employ a "straight-through" cable
assembly. Contact Comtech EF Data Product Support for detailed
cabling instructions when cabling between converters in redundant
applications.
4.2.4.2 Removable Module Operation in Non-Redundant
(Standalone) Applications
A converter may use a Transmit Switch Module (TSM) or a Receive Switch
Module (RSM) in standalone configurations if an IOM (Figure 4-17) is
unavailable.
Note that the High Speed Bus 'J3 | HSB' connector is not used in standalone
configurations. If a module other than an IOM is used, only the 'J4 | IF' and 'J5 |
RF' connectors are used to connect directly to the user input/output signal
sources (Figure 4-18).

Figure 4-17. DT-4500 Standalone Cabling Example to IOM

Figure 4-18. DT-4500 Standalone Cabling Example to RSM

4–18
MN/DT4500.IOM
Revision 2