Philips FC7070/01 User Manual page 27

Problem Possible cause
I have just filled The tank full/tank
the clean water empty light may flash
tank, but the a few times when
tank full/tank you switch on the
empty light keeps appliance after you
flashing when I have filled the clean
switch on the water tank.
appliance.
If the tank full/tank
empty light continues
to flash after filling,
the clean water tank
may not be assembled
properly.
Water drips out Water leaks from
of the appliance. the clean water tank
because you have not
put the cap on the
clean water tank or
you have not fastened
this cap properly.
Water leaks from
the clean water tank
because you overfilled
the clean water tank.
Water leaks from the
dirty water tank because
you tilted the upper
body too far backwards
or because you placed
the appliance on its side.
This caused wastewater
to run out of the dirty
water tank.
I cannot remove You probably tried
the mopping to remove them by
brushes. pulling at the wrong
side.
I cannot tilt The appliance is locked
the appliance in parking position.
backwards
without the
nozzle coming off
the floor.
Solution
When you switch on the appliance after you have filled the
clean water tank, the tank full/tank empty light may flash a
few times and the appliance may switch off automatically.
This happens because it takes a few seconds for the water
to reach the mopping nozzle. Release the power-on button.
Then push the unlock slide forwards and press the power-
on button to switch on the appliance again (see chapter
'Preparing for use', section 'Filling the clean water tank').
Make sure you place the clean water tank properly and
that the lever is locked (see chapter 'Preparing for use',
section 'Filling the clean water tank').
Remove the clean water tank from the appliance. Put
the cap on the water tank if it was not there or turn
the cap clockwise to fasten it (see chapter 'Preparing for
use', section 'Filling the clean water tank').
Do not fill the clean water tank beyond the MAX
indication. If you do, water may spill from the clean
water tank when you fasten the cap (see chapter
'Preparing for use', section 'Filling the clean water tank').
Do not tilt the upper body of the appliance too far
backwards, for instance when you clean under a low
table. Do not place the appliance on its side when
there is wastewater in the dirty water tank (see chapter
'Important', section 'Caution').
grab the lime green grips of the brushes and pull the
brushes up a little. Then you should be able to slide them
off the projection on the other side (see chapter 'Cleaning
and maintenance', section 'Cleaning the mopping nozzle').
Press the parking position release button with your foot
to unlock the appliance from parking position (see chapter
'Using your AquaTrio', section 'Pausing during use').
27