Philips FC7070/01 User Manual page 22

Problem
The appliance
stopped working.
The appliance
does not apply
water to the
floor because it
has picked up
something.
22
Possible cause
You released the
power-on button.
The clean water tank
may be empty or the
dirty water tank may
be full, although you
did not notice the light
indicating this.
The ventilation
openings are blocked.
The active protection
system may have
been activated for
three reasons: (1) the
appliance picked up
a foreign object, (2)
the mopping brushes
are too wet or (3)
you have moved the
appliance over a carpet.
The mopping brushes
automatically stopped
rotating because they
encountered too
heavy resistance. The
appliance continues to
make a sound, but it
does not work properly.
Solution
The appliance is equipped with a safety lock. You first have
to push the unlock slide forwards to unlock the power-on
button and then you can press the power-on button to
switch on the appliance. Release the unlock slide when
the appliance switches on, but keep the power-on button
pressed (see chapter 'Using your AquaTrio').
To check if this is the cause, switch on the appliance and
see if the tank full/tank empty light starts flashing or lights
up continuously. If the light flashes, fill the clean water
tank (see chapter 'Preparing for use', section 'Filling the
clean water tank'). If the light lights up continuously, empty
the dirty water tank (see chapter 'Using your AquaTrio',
section 'Emptying the dirty water tank').
Check all four ventilation openings for any objects that
block the ventilation openings. If necessary, remove
these objects. let the appliance cool down before you
continue cleaning. See chapter 'Your AquaTrio' for the
location of the ventilation openings.
Release the power-on button to switch off the
appliance. Put the appliance upright in parking position
('click') and pull the plug out of the wall socket. Open
the mopping nozzle lid, remove the mopping brush
cover and remove the object. Reinsert the mopping
brush cover, close the mopping nozzle lid, put the plug
in the wall socket and switch on the appliance again
(see chapter 'Using your AquaTrio', section 'Active
protection system is activated'). If you find no object,
the active protection system may have been activated
because the mopping brushes are too wet (see
next cause and solution) or because you moved the
appliance over a carpet. Pull the plug out of the wall
socket, open and close the mopping nozzle lid, put the
plug in the wall socket again, switch on the appliance
and start cleaning again.
If the above solutions did not help and the appliance still
does not work, switch on the appliance for at least 10
seconds. Then open and close the mopping nozzle lid,
switch on the appliance and start cleaning again.