Philips FC7070/01 User Manual page 23

Problem Possible cause
The mopping nozzle lid
is not closed properly.
The sound of the
appliance decreases
and the appliance no
longer applies water
to the floor because
the mopping brushes
do not rotate and the
appliance does not
mop up anything.
I cannot close the The mopping brush
mopping nozzle cover is not present or
lid. is not placed properly.
The appliance You have moved the
leaves water appliance sideways.
traces on the
floor.
You have moved the
appliance across a
threshold while it was
switched on.
You have moved the
appliance with its
nozzle touching the
floor while it was
switched off.
You lifted the appliance
up from the floor
immediately after you
switched it off.
The wheels are
blocked.
Solution
Make sure the mopping brushes and the mopping brush
cover are assembled correctly. Close the mopping nozzle
lid properly. Make sure you press the lid until it locks with
a click (see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle').
Place the mopping brush cover into the mopping
nozzle properly and then close the mopping nozzle
lid (see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle').
Only move the appliance forwards and backwards (see
chapter 'Using your Aqua Trio', section 'Cleaning tips').
Make sure the mopping brushes stay in contact with the
floor. Switch off the appliance before you pull it over a
threshold to prevent water traces on the floor or to
prevent water from splashing from the mopping nozzle
(see chapter 'Using your Aqua Trio', section 'Cleaning tips').
If you want to avoid water traces on the floor, move
the appliance by carrying it by its carrying handle or by
tilting it so that it rests on its wheels for easy transport
(see chapter 'Storing and moving your AquaTrio').
After you switch off the appliance, move it forwards
and backwards a few times to remove the liquid that
is present between the two mopping brushes. If you
switch off the appliance and lift it up immediately
afterwards, the water that was present between the
brushes leaves a trace of water on the floor.
Check the condition of the wheels. Remove the dirt
that blocks the wheels.
23