Philips FC7070/01 User Manual page 24

Problem
The appliance
does not clean as
well as it used to.
24
Possible cause
The active protection
system may have
been activated for
three reasons: (1) the
appliance picked up
a foreign object, (2)
the mopping brushes
are too wet or (3)
you have moved the
appliance over a carpet.
The mopping brushes
automatically stopped
rotating because they
encountered too
heavy resistance. The
appliance continues to
make a sound, but it
does not work properly.
The active protection
system has been
activated because the
brushes are too wet.
The mopping brushes
automatically stopped
rotating because they
encountered too heavy
resistance.
Solution
Release the power-on button to switch off the
appliance. Put the appliance upright in parking position
('click') and pull the plug out of the wall socket. Open
the mopping nozzle lid, remove the mopping brush
cover and remove the object. Reinsert the mopping
brush cover, close the mopping nozzle lid, put the plug
in the wall socket and switch on the appliance again
(see chapter 'Using your AquaTrio', section 'Active
protection system is activated'). If you find no object,
the active protection system may have been activated
because the mopping brushes are too wet (see
next cause and solution) or because you moved the
appliance over a carpet. Pull the plug out of the wall
socket, open and close the mopping nozzle lid, put the
plug in the wall socket again, switch on the appliance
and start cleaning again.
If the above solutions did not help and the appliance still
does not work, switch on the appliance for at least 10
seconds. Then open and close the mopping nozzle lid,
switch on the appliance and start cleaning again.
Release the power-on button to switch off the appliance.
Put the appliance upright in parking position ('click') and
pull the plug out of the wall socket. Remove the mopping
brushes from the mopping nozzle and remove excess
water from the mopping brushes by squeezing them over
a sink (see chapter 'Cleaning and maintenance', section
'Cleaning the mopping nozzle'). Then you can reinsert the
mopping brushes, reinsert the mopping brush cover, close
the mopping nozzle lid, put the plug in the wall socket
and switch on the appliance again (see chapter 'Cleaning
and maintenance', section 'Reassembling the mopping
nozzle'). If this does not work, let the mopping brushes
dry (see chapter 'Cleaning and maintenance', section
'Cleaning the mopping nozzle').