Philips FC7070/01 User Manual page 25

Problem Possible cause
The mopping nozzle lid
is not closed properly.
The sound of the
appliance decreases
and the appliance no
longer applies water
to the floor because
the mopping brushes
do not rotate and the
appliance does not
mop up anything.
The inside of the
mopping nozzle is too
dirty.
The mopping brushes
are not present.
The mopping brushes
are worn.
The sound of The active protection
the appliance system may have
changed while been activated for
cleaning. three reasons: (1) the
appliance picked up
a foreign object, (2)
the mopping brushes
are too wet or (3)
you have moved the
appliance over a carpet.
The mopping brushes
automatically stopped
rotating because they
encountered too
heavy resistance. The
appliance continues to
make a sound, but it
does not work properly.
Solution
Make sure the mopping brushes and the mopping brush
cover are assembled correctly. Close the mopping nozzle
lid properly. Make sure you press the lid until it locks with
a click (see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle').
Clean the mopping nozzle (see chapter 'Cleaning and
maintenance', section 'Cleaning the mopping nozzle').
Place the mopping brushes in the mopping nozzle
(see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle').
Replace the mopping brushes (see chapter 'Replacing
the mopping brushes').
Release the power-on button to switch off the
appliance. Put the appliance upright in parking position
('click') and pull the plug out of the wall socket. Open
the mopping nozzle lid, remove the mopping brush
cover and remove the object. Reinsert the mopping
brush cover, close the mopping nozzle lid, put the plug
in the wall socket and switch on the appliance again
(see chapter 'Using your AquaTrio', section 'Active
protection system is activated'). If you find no object,
the active protection system may have been activated
because the mopping brushes are too wet (see
next cause and solution) or because you moved the
appliance over a carpet. Pull the plug out of the wall
socket, open and close the mopping nozzle lid, put the
plug in the wall socket again, switch on the appliance
and start cleaning again.
If the above solutions did not help and the appliance still
does not work, switch on the appliance for at least 10
seconds. Then open and close the mopping nozzle lid,
switch on the appliance and start cleaning again.
25