Asko DWCBI241.S.AU Operating Instructions Manual page 10

Red - Do not load
You should not load any more dishes (risk of poorer dishwashing result).
Flashing red indicates a problem. See also Chapter Troubleshooting.
Green - Unload
The dishwashing program is finished. Standby light for 60 minutes.
Stopping or changing a program
If you want to change program after starting the dishwasher, open the
door then press and hold Start/Stop for three seconds. Add more
detergent if the lid of the detergent dispenser has opened. Then choose
a new program, press Start/Stop and close the door.
If you want to load more dishes
Open the door. The dishwasher stops automatically. Add the dishes
and close the door. After a while, the dishwasher continues the
program.
If the dishwasher is turned off due to a
power failure
If the dishwashing program was not finished, the interrupted program
continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or the
door is open for more than 2 minutes.
Once the program has finished
Once the program has finished, "END" appears on the display.
10
At the end of the program, you will hear a short beep. Chapter Settings
describes how to change this function.
The dishwasher switches off automatically after the program ends.
Turn off the water tap after each use.
How to get the best drying results
Fully load the dishwasher.
Angle dishes with hollows, such as cups, so that the rinse water
will run off. This is also important for plastic items.
Top up with rinse aid or increase the rinse aid dosage level.
Open the door a little once the program has finished.
Allow the dishes to cool before unloading the dishwasher.
Unloading the dishwasher
Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher
before unloading them.
Unload the lower basket first to avoid any water drops from the upper
basket falling onto the dishes in the lower basket.