I/O Signal Wire Connections; Wiring - Omron V600 Operation Manual

I/O Signal Wire Connections

3-2

I/O Signal Wire Connections

Used Connector Pins
3-2-1

Wiring

Note
Type Name
Input ID-RESET
Output ID-RUN
ID-BUSY
ID-ERROR
General-purpose output
To connect to a Terminal Block, use an OMRON Cable preassembled with the
special connector or attach the special connector (sold separately) to a cable
yourself.
(1) Do not supply a voltage to the input terminals that exceeds the I/O cir-
cuit's specified input voltage range. Likewise, do not connect a voltage or
load that exceeds the output circuit's max. switching capacity.
(2) When the power supply terminals are marked with + and − indicators, ver-
ify that the power supply wires have not been reversed accidentally.
(3) When the equipment is subject to EC Directives (the Low Voltage Direc-
tives), a DC power supply with reinforced insulation or double insulation
must be used for the I/O power supply.
(4) Check all connector wiring thoroughly before turning ON the power sup-
ply.
(5) Do not pull on the cable. Doing so may separate the cable from the con-
nector.
(6) Do not bend the cable beyond its natural bending radius. Doing so may
damage the cable.
(7) Do not connect a 24-V DC output device to a line driver input. Doing so
may damage the internal circuits.
Pin No.
1 24 V DC
5 0 V
31 ID-RUN output
32 ID-BUSY output
33 ID-ERROR output
37 Power supply input (+V) for
the output
39 or 40 Output COM
1 2
3 4
5 6
7 8
9 10
11 12
13 14
15 16
17 18
19 20
21 22
23 24
25 26
27 28
29 30
31 32
33 34
35 36
37 38
39 40
Section 3-2
Contents
15