Proper Selection Of The Power Supply Cord - Olympus DP21-SAL Instructions Manual

PROPER SELECTION OF THE POWER SUPPLY CORD

If no power supply cord is provided, please select the proper power supply cord for the equipment by referring to " Specifications " and
" Certified Cord " below:
CAUTION: In case you use a non-approved power supply cord for Olympus products, Olympus can no longer warrant the
electrical safety of the equipment.
Voltage Rating
Current Rating
Temperature Rating
Length
Fittings Configuration
A power supply cord should be certified by one of the agencies listed in Table 1 , or comprised of cordage marked with an
agency marking per Table 1 or marked per Table 2. The fittings are to be marked with at least one of the agencies listed in
Table 1. In case you are unable to buy locally in your country the power supply cord which is approved by one of the
agencies mentioned in Table 1, please use replacements approved by any other equivalent and authorized agencies in
your country.
Country
Argentina
Australia
Austria
Belgium
Canada
Denmark
Finland
France
Germany
Ireland
Downloaded from ManualsNet.com
125V AC (for 100-120V AC area) or, 250V AC (for 220-240V AC area)
6A minimum
60°C minimum
3.05 m maximum
Grounding type attachment plug cap. Opposite terminates in molded-on IEC con-
figuration appliance coupling.
Certification
Agency
Mark
IRAM
SAA
ÖVE
CEBEC
CSA
DEMKO
FEI
UTE
VDE
NSAI
search engine
Specifications
Table 1 Certified Cord
Country
Italy
Japan
Netherlands
Norway
Spain
Sweden
Switzerland
United
Kingdom
U.S.A.
Certification
Agency
Mark
IMQ
JET, JQA
KEMA
NEMKO
AEE
SEMKO
SEV
ASTA
BSI
UL
DP21-SAL
76