Olympus DP21-SAL Instructions Manual page 16

@
@
³
2
13
Downloaded from ManualsNet.com
2
³
Fig. 3
5
|
Fig. 4
search engine
3
Connecting the Display Cable
CAUTION Make sure to use the DVI protection adapter always, since some
electrical failure may be caused, if the control box D21-CB is
directly connected to the display.
1. Insert DVI protection adapter ² all the way into the connector @ on the
control box D21-CB and secure the clamping screws on both sides of
the DVI protection adapter.
2. Insert the connector ³ of the cable provided with the display all the way
into the DVI protection adapter ² and secure the clamping screws on
both sides of the connector.
}When disconnecting the display cable, disconnect only the connector of
the display cable ³, and do NOT disconnect the DVI protection adapter
² from the control box D21-CB.
}Use a DVI cable matching the display as the display cable. The DVI
protection adapter is compatible with either the DVI-I, D or A connector.
4 Connecting the AC Adapter
CAUTION · Always use the AC adapter provided by Olympus. Using other
AC adapter will result in malfunction or damage.
· The cords and cables are vulnerable to bend or twist. Do not
apply excessive force to them.
1. Pass the cable of the AC adapter through the holder @ on the control
box D21-CB and close the holder @ securely. This measure is required to
prevent the cable from easily disconnecting from the control box D21-CB.
2. Insert the output plug ² of the AC adapter into the DC input connector ³
of the control box D21-CB.
Always use the power cord provided by Olympus. If no power
CAUTION
cord is provided with the camera head, please select the proper
power cord by referring to chapter "PROPER SELECTION OF
THE POWER SUPPLY CORD" at the end of this instruction
manual.
3. Insert the connector | of the power cord into the input connector 5 of
the AC adapter.
4. Insert the power cord plug into the power outlet. Connect the power cord
correctly and ensure that the grounding terminals of the power supply
and wall outlet are properly connected. If the equipment is not grounded/
earthed, Olympus can no longer warrant the electrical safety performance
of the equipment.
}The AC adapter and control box D21-CB generate heat after long hours
of use, but this is not malfunction.
(Fig. 3)
(Fig. 4)