Proper Selection Of The Power Supply Cord - Olympus DP20 Instructions Manual

PROPER SELECTION OF THE POWER SUPPLY CORD

If no power supply cord is provided, please select the proper power supply cord for the equipment by referring to " Specifications " and
" Certified Cord " below:
CAUTION: In case you use a non-approved power supply cord for Olympus products, Olympus can no longer warrant the
electrical safety of the equipment.
Voltage Rating
Current Rating
Temperature Rating
Length
Fittings Configuration
A power supply cord should be certified by one of the agencies listed in Table 1 , or comprised of cordage marked with an
agency marking per Table 1 or marked per Table 2. The fittings are to be marked with at least one of agencies listed in
Table 1. In case you are unable to buy locally in your country the power supply cord which is approved by one of the
agencies mentioned in Table 1, please use replacements approved by any other equivalent and authorized agencies in
your country.
Country
Argentina
IRAM
Australia
SAA
Austria
ÖVE
Belgium CEBEC
Canada CSA
Denmark DEMKO
Finland
FEI
France
UTE
Germany
VDE
Ireland
NSAI
Specifications
125V AC (for 100-120V AC area) or, 250V AC (for 220-240V AC area)
6A minimum
60°C minimum
3.05 m maximum
Grounding type attachment plug cap. Opposite terminates in molded-on IEC con-
figuration appliance coupling.
Table 1 Certified Cord
Certification
Agency
Mark
Country Agency
Italy
IMQ
JET, JQA , TÜV,
Japan
UL-APEX / MITI
Netherlands
KEMA
Norway
NEMKO
Spain
AEE
Sweden
SEMKO
Switzerland
SEV
United
ASTA
Kingdom
BSI
U.S.A.
UL
DP20
Certification
Mark
49