Table of Contents
Advertisement
3
Assembling the Brush Kit
to the Machine
Parts needed for this procedure:
2
Lower brush bracket
4
Self-tapping, flange-head screw (6 x 20 mm)
2
Capscrew (6 x 20 mm)
4
Washer (6 mm)
2
Locknut (6 mm)
Removing the Wheels
1.
Remove the flange locknut (3/8 inch) that
secures the wheel to the axle, and remove the
wheel
(Figure
5).
1. Axle
2. Wheel
2.
Repeat step
1
for the wheel at the other side of
the machine.
Removing the Front Fins
1.
Tip the machine onto its side with the air filter
up
(Figure
6).
Figure 5
3. Flange locknut (3/8 inch)
2.
Remove the 7 self-tapping, flange-head screws
(6 x 20 mm) that secure the front fins to the
supports of the mower deck, and remove the
front fins
Note:
You will not use these front fins with the
groomer brush kit.
g284602
1. Support (front fin—mower
deck)
2. Front fins
5
Figure 6
(Figure
7).
Figure 7
3. Self-tapping, flange-head
screw (6 x 20 mm)
g283871
g284601
Advertisement
Table of Contents
