Toro 134-3722 Installation Instructions Manual page 3

3. Disconnect the spark-plug wire from the spark
plug; refer to the Operator's Manual for your
machine.
2
Assembling the Brush
Mount
Parts needed for this procedure:
1 Brush-adjustment bracket
1 Groomer brush
4 Capscrew (8 x 60 mm)
8 Washer (8 mm)
4 Locknut (8 mm)
2 Brush-height plate
2 Carriage bolt (8 x 25 mm)
2 Knob
2 Strut (brush)
2 Capscrew (6 x 20 mm)
4
Washer (6 mm)
2 Locknut (6 mm)
Assembling the Groomer Brush to
the Brush-Adjustment Bracket
1. Capscrew (8 x 60 mm)
2. Washer (8 mm)
3. Brush-adjustment bracket
1. Align the holes in the brush-adjustment bracket
with the holes in the groomer brush as shown
in Figure 1.
Figure 1
4. Locknut (8 mm)
5. Groomer brush
2. Assemble the brush-adjustment bracket to the
groomer brush
x 60 mm), 8 washers (8 mm), and 4 locknuts
(8 mm).
3. Tighten the capscrews and locknuts.
Assembling the Brush-Adjustment
Bracket to the Brush Mount
1. Assemble the brush and brush-adjustment
bracket to the brush mount as shown in
Note:
Ensure that the rod ends of the handle
for the brush-adjustment bracket align through
the slots in the brush mount.
1. End of the handle
(brush-adjustment
bracket)
2. Assemble a brush-height plate over the rod end
of the handle for the brush-adjustment bracket
as shown in
g284576
3
(Figure 1) with 4 capscrews (8
Figure 2
2. Slot (brush mount)
Figure 3.
Figure 2.
g284577