How To Use Basic Functions; Basic Operations - Carrier RG10B2BGEF Owner's Manual

2. DISPLAY AND BUTTONS
2.2 BUTTONS
Mode
Press the mode button to
switch the mode in turn.
NOTE: HEAT mode is not supported
by the cooling only appliance.
On/Off
Press to start operation.
Press again to stop.
Temperature UP
Increases temperature in
1 C increments.
Max. Temp. is 30 C .
SET
Scrolls through operation
functions as follows:
Fresh( ) Sleep( ) 

Follow Me( )

AP mode( ) Fresh....

The selected symbol will flash on
the display area, press the OK
button to confirm.
OK
Used to confirm the selected
functions.
Fan Speed
Press to select the fan speed.
Turbo
Enables unit to reach preset
temperature in shortest possible time.
MODEL: RG10A5(U)/BGEF
RG10A11(U)/BGEF(20-28 C)
NOTE:
1. Above illustration shows all the features. For actual model, only the relevant parts are shown.
2. Buttons design might be slightly different from the actual one.
05
X-ECO
Press to enter the energy
efficient mode.
TIMER
Set timer to turn unit on or off.
Temperature Down
Decreases temperature in 1 C
increments. Min. Temp. is 17 C.
My Mode
Press to memorize or resume
X-ECO
your favorite pre-settings.
Swing
Starts and stops the horizontal louver
movement. Hold down for 2 seconds
to initiate vertical louver auto swing
feature(some units).
Clean
My Used to start/stop the Self Clean
Mode
or Active Clean function.
(Model dependent).
LED
Press to turn on/off the LED
display. Pressing 5 more seconds
to alternate the indoor display
between setting temperature
and room temperature
(Model dependent).
LOCK
Press together Clean button and
Turbo button at the same time more
than 5 seconds to activate Lock
function.

3. HOW TO USE BASIC FUNCTIONS

3.1 BASIC OPERATIONS

ATTENTION
Before operation, please ensure the unit is plugged in and power is available.
Select AUTO mode Set your desired temperature
Mode
AUTO
Mode
NOTE:
1. In AUTO mode for heat pump system, the air conditioner can automatically choose the mode of
Cool, Heat or Fan by sensing the difference between the actual room temperature and setting
temperature.
2. In AUTO mode for cooling only system, the air conditioner can automatically choose the mode of
Cool or Fan by sensing the difference between the actual room temperature and setting temperature.
3. In AUTO mode, fan speed can not be set.
Select COOL/HEAT mode
Set the temperature
COOL
or
Mode
HEAT
Mode
Select DRY mode Set the temperature
Mode
DRY
Mode
NOTE:
In DRY mode, fan speed can not be set since it has already been automatically controlled.
Select FAN mode Set the fan speed
FAN
Mode
Mode
Turn on the air conditioner
Turn on the air conditioner
Set the fan speed
Turn on the air conditioner
Turn on the air conditioner
06