To Install The Outdoor Unit; To Provide Drainage; To Prevent The Outdoor Unit From Falling Over - Daikin Altherma 3 M Installation Manual

4 Unit installation
4.2.2

To install the outdoor unit

CAUTION
To avoid injury, do NOT touch the air inlet or aluminium
fins of the unit.
CAUTION
Do NOT remove the protective cardboard before the unit is
installed properly.
1 Carry the unit using the slings attached to the unit. Pull up both
sides of the sling at the same time to prevent disconnection of
the sling from the unit.
2 While handling the unit:
▪ Keep both sides of the sling level.
▪ Keep your back straight.
±110
kg
3 Install the outdoor unit as follows:
▪ (1) Put the unit into position.
▪ (2) Remove the slings (by pulling 1 side of the sling).
▪ (3) Fix the unit.
Installation manual
10
2 2
a
1
a Air outlet
NOTICE
Properly align the unit. Make sure the backside of the unit
does NOT protrude.
4 Remove the protective cardboard and instruction sheet.
a
b
a Protective cardboard
b Instruction sheet
4.2.3

To provide drainage

Make sure that condensation water can be evacuated properly.
INFORMATION
If necessary, you can use a drain pan (field supply) to
prevent drain water from dripping.
NOTICE
If the drain holes of the outdoor unit are blocked up,
provide space of at least 300 mm below the outdoor unit.
NOTICE
If the unit CANNOT be installed fully level, always make
sure that the inclination is towards the backside of the unit.
This is required to guarantee proper drainage.
4.2.4 To prevent the outdoor unit from falling
over
In case the unit is installed in places where strong wind can tilt the
unit, take following measure:
1 Prepare 2 cables as indicated in the following illustration (field
supply).
2 Place the 2 cables over the outdoor unit.
3 Insert a rubber sheet between the cables and the outdoor unit
to prevent the cables from scratching the paint (field supply).
EBLA04~08E2V3+E23V3 + EDLA04~08E2V3+E23V3
2
a
3
2×
Daikin Altherma 3 M
4P685229-1A – 2022.05