Installation - Smeg FMI125S Instruction Manual

5 Installation

1. This appliance is only intended for
domestic use.
2. This oven is intended for built-in use only.
It is not intended for counter-top use or
for use inside a cupboard.
3. The appliance must only be connected to
a properly installed earthed socket.
4. The mains voltage must correspond to
the voltage specified on the rating plate.
5. The socket must be installed and
connecting cable must only be replaced
by a qualified electrician. If the plug is no
longer to accessible following
installation, an all-pole disconnecting
device must be present on the installation
side with a contact gap of at least 3mm.
6. Adapters, multi-way strips and extension
leads must not be used. Overloading
can result in a risk of fire
High temperatures inside the oven
after use
Danger of burns
• The accessible surface may be hot
during operation.
40
Installation
Electrical connection
The oven is fitted with a plug and must be
only connected to a properly installed
earthed socket.
In accordance with the appropriate
regulations, the socket must only be
installed and the connecting cable must
only be replaced by a qualified electrician.
If the plug is no longer accessible following
installation and all-pole isolating switch
must be present on the installation side with
a contact gap at least 3mm.
A. Fitted units
The installation cabinet must not have a
back panel behind the appliance. Minimum
installation height: 850 mm.
Ventilation slots and intakes must not be
covered.