Sundance Spas CAMDEN 780 Owner's Manual page 24

780 SERIES
Important Heater details:
• The maximum temperature for which the spa can be set is
104°F (40°C) and the minimum is 65°F (18°C).
• For North American 2-pump spas powered by a 40 amp
service, jets pump #1 must be set to low speed and jets
pump #2 must be turned off to operate the heater.
• For Export (50 Hz) 2-pump spas powered by a 20 amp
service, jet pump #1 must be set to low speed and jets
pump #2 must be turned off to operate the heater.
• Setting the thermostat at maximum will not accelerate the
heating process. This will only result in a higher ultimate
temperature.
• The heater operates until the water reaches the
programmed "set temperature", then turns off. The heater
will reactivate after the water cools to approximately 1.5°
below the "set temperature".
8. Place Cover On Spa
• Keeping the insulating cover in place anytime the spa is not in
use will reduce the time required for heating, thereby minimizing
operating costs.
• The time required for initial heat-up will vary depending on the
starting water temperature.
dANGER:
Check water temperature carefully before entering hot tub!
!
Excessive water temperature can cause burns, welts and
body temperature to rise, hyperthermia (over-heating).
decontamination Procedure (Steps 9-15)
Steps 9-15 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable at 3.0-4.0 ppm chlorine or 2.0-4.0 ppm bromine after
performing steps 1-6 above.
9. Add 2.5 ounces (71 g) of sodium dichlor for every 100 gallons (378
Liters) of water. Refer to the table (page 21) for approximate water fill
volume by model.
Page 20
RISK OF PERSONAL INjURY.