Sundance Spas CAMDEN 780 Owner's Manual page 2

Attention New Spa Owner!
Congratulations on the purchase of your new Sundance
following is a list of automated functions and maintenance recommendations
for your new spa. Automated functions have been listed below in an attempt
to suppress any operational concerns you may have during startup and the
first 24-hours of ownership! Maintenance recommendations are listed in an
attempt to stress their importance in protecting your new spa.
Automated Operations
Approximately two minutes after power is applied to the spa, the first filtration/
heating cycle turns on pump 1 (Section 9.0, page 25). In Certa/Chelsee/
Hamilton models, an automatic five minute "blow-out" function also activates
pump 2 for a period of five minutes to flush all lines. Then, after five minutes,
pump 2 turns off and pump 1 continues to operate for the duration of the cycle.
Note: This function only occurs during the first filtration/heating cycle each day.
Maintain Healthy Spa Water
Always maintain your hot tub's water chemistry within the following
parameters as defined by the Association of Pool and Spa Professionals/USA:
pH
Free chlorine
Free bromine
Total Alkalinity
Calcium Hardness
!
TO dECREASE RISK OF INFECTION OR dISEASE!
tain your spa filter as outlined below to ensure healthy spa water.
Refer to pages 31-32 for additional information.
Required Filter Maintenance
Your new hot tub is equipped with an advanced 2-stage MicroClean ™ water
filtration system that provides unsurpassed water quality! To ensure maximum
water quality at all times, you should clean and reuse the larger pleated filter
cartridge every month and replace (throw away) the smaller MicroClean filter
cartridge every 3 months, or earlier as necessary. The smaller MicroClean
filter cartridge is designed to be thrown away! Attempts to reuse this filter
cartridge may result in the re-release of unwanted particles back into the spa.
See pages 31-32 for detailed filter cartridge replacement instructions.
Required Water Maintenance
!
TO dECREASE RISK OF INFECTION OR dISEASE!
replace the spa's water every 3 months. The frequency depends on a number
of variables including frequency of use, number of users, and attention paid
to water quality maintenance. You will know it is time for a change when
you cannot control sudsing and/or you can no longer get the normal feel or
sparkle to the water, even though the key water balance measurements are
all within the proper parameters. See pages 37-39 for additional information.
®
7.4-7.6
3.0-4.0 ppm
2.0-4.0 ppm
100-120 ppm
150-250 ppm
780 Series spa! The
Always main-
You should