Mercedes-Benz A-Class Owner's Manual page 345

342 Wheels and tyres
Tyre pressures will be displayed after a few
R
minutes of driving
Tyre pressure monitor active: the teach-in
R
process of the system is not yet complete.
The tyre pressures are already being moni‐
tored.
Compare the tyre pressure with the recom‐
#
mended tyre pressure for the current operat‐
ing condition ( page 340). Observe the
→
notes on tyre temperature (
% The values displayed in the multifunction dis‐
play may deviate from those of the tyre pres‐
sure gauge as they refer to sea level. At high
altitudes, the tyre pressure values indicated
by a pressure gauge are higher than those
shown by the on-board computer. In this
case, do not reduce the tyre pressure.
Make sure to observe the following further rela‐
ted subject:
Notes on tyre pressure (
R
Restarting the tyre pressure monitoring sys‐
tem
Requirements:
The recommended tyre pressure is correctly
R
set for the respective operating status on
each of the four wheels (
Restart the tyre pressure monitoring system in
the following situations:
The tyre pressure has changed.
R
The wheels or tyres have been changed or
R
newly fitted.
page 339).
→
On-board computer:
,
Swipe downwards on Touch Control on the
#
left-hand side of the steering wheel.
The
page 339)
values?
→
tion display.
To begin restart, press Touch Control on the
#
left-hand side of the steering wheel.
The
shown in the multifunction display.
Current warning messages are deleted and
page 339).
→
the yellow h warning lamp goes out.
After you have been driving for a few
minutes, the system checks whether the cur‐
rent tyre pressures are within the specified
range. The current tyre pressures are then
accepted as reference values and monitored.
Make sure to observe the following further rela‐
ted subject:
Notes on tyre pressure (
R
Service Tyres
.
Use current pressures as new reference
message is shown in the multifunc‐
Tyre press. monitor restarted
page 339)
→
message is