Upright Tube Assembly - Spirit XT485 Owner's Manual

1

UPRIGHT TUBE ASSEMBLY

1. Install the four speed nuts (128) onto the tabs of the frame.
2. Take the Left and Right upright tubes (part numbers 5 & 4) and slip the upright covers (67 & 61
left, 66 & 62 right) onto the tubes (observe the cover orientation is correct). Connect the Middle
Console Cable (50) that exits from the bottom of the right upright tube with the lower Console
Cable (49). NOTE: Partially tighten all bolts in this step. This will allow for easier
console assembly.
3. Insert Right and Left Uprights (4) and (5) into the Frame Base (2) and attach with eight Button
Head Socket Bolts (130) using the Allen wrench/screwdriver (131). Attach two more Button
Head Socket Bolts (130) and two Flat Washers (147) on the inside surface of the upright tubes.
Be careful not to pinch the wire when installing the upright.
HARDWARE
#130. 5/16" x 15mm
Button Head Socket
Bolt (10 pcs)
XT485 Treadmill
#147. 5/16" x 18 x 1.5T
Flat Washer
(2 pcs)
6
#128. M5 Speed Nut
Clip (4 pcs)