1: Mounting The Ra-1000 - Honeywell Gamewell-FCI GWF-7075 Installation And Operation Manual

RA-1000 Remote Annunciator Installation
4.5.1 Mounting the RA-1000
This section of the manual describes mounting the remote annunciator. The annunciator can be flush- or surface-mounted. Figure 4.10
shows the parts of the annunciator. Instructions for disassembling and mounting appear on the following pages.
The RA-1000 comes from the factory fully assembled. You must disassemble it for mounting. To disassemble the annunciator, use a 5/64
hex wrench to remove the set screws, located on the bottom of the annunciator bezel. (See Figure 4.11 for the location of the set screws).
.
Flush Mounting
This section of the manual describes flush mounting. You can flush-mount with or without an electrical box.
Flush Mounting with an Electrical Box

The RA-1000 annunciator can be used with the following types of electrical boxes: 4S, single-gang, and double-gang.
If you use an electrical box, the box must be 1-3/8" set back from the face of the wall to accommodate the annunciator. You must use two
by fours (or larger) Studs to connect to an electrical box.
GWF-7075 Addressable Fire Alarm Control Panel Manual — P/N LS10147-002GF-E:E 06/11/2019
Electronic Assembly
(Front View)
Bezel (external ring)
Assembled Annunciator also includes
mounting wires and 4 screws.
Figure 4.10 Annunciator Parts
Use knockouts to insert
wires for flush mounting.
(located in all corners).
When you disassemble
annunciator, to remove the
bezel, loosen set screws.
Figure 4.11 Annunciator Back Box and Bezel Details
Examples of use of Electrical Box
wall studs
Annunciator
backbox outline
Electrical Box
Figure 4.12 Placement of Electrical Box for Flush Mounting
Back Box
Use knockouts
for surface
mounting
Knockouts-
holes
Standoff
throughout
Screws for placement
of mounting wires
(top & bottom)
Electrical Box Placement
Annunciator backbox
1 3 / 8 "
Electrical boxes must
be installed 1 3/8" back
from the wall.
Electrical box
applications require
a minimum 2x4 construction.
Sheet rock
Control Panel Installation
Sheet rock
Electrical Box
23