Table of Contents
Advertisement
Steps
1. Align and place the display panel on the slots of the display-assembly base.
2. Route the display backlight, touchscreen and display cable through the slots on the display assembly base.
3. Place the display-assembly base on a clean and flat surface with the display panel facing down.
4. Replace the 12 screws (M3x5) that secure the display panel to the display-assembly base.
5. Replace the five screws (M3x5) that secure the display panel to the display-assembly base.
NOTE:
The screws that secure the middle frame and display panel to the display-assembly base are silver in color and
etched with "LCD" around the screw holes.
Next steps
1. Install the
system
board.
2. Install the
heat
sink.
3. Install the
wireless
card.
4. Install the
M.2 2230 solid-state drive
5. Install the
memory
module.
6. Install the
system-board
7. Install the
hard
drive.
8. Install the
I/O
cover.
9. Install the
back
cover.
10. Install the stand.
11. Follow the procedure in
62
Removing and installing components
or
M.2 2280 solid-state
shield.
After working inside your
drive.
computer.
Advertisement
Table of Contents
