Table of Contents
Advertisement
Steps
1. Align the screw holes on the system board with the screw holes on the display-assembly base.
2. Replace the six screws (M3x5) that secure the system board to the display-assembly base.
3. Replace the solid-state drive screw mount (M3x4) that secures the system board to the display-assembly base.
4. Connect the display cable to the system board.
5. Connect the power-button board cable to the system board and close the latch to secure the cable.
6. Connect the media-card reader cable to the system board.
7. Connect the microphone-module cable to the system board.
8. Connect the speaker cable to the system board.
9. Connect the fan cable to the system board.
10. Connect the backlight cable to the system board.
11. Connect the camera cable to the system board.
12. Connect the touchscreen cable to the system board.
NOTE:
This cable is only available on computers that support touch option.
Next steps
1. Install the
heat
sink.
2. Install the
M.2 2230 solid-state drive
3. Install the
wireless
card.
4. Install the
memory
module.
5. Install the
system-board
6. Install the
I/O
cover.
7. Install the
back
cover.
8. Install the stand.
9. Follow the procedure in
NOTE:
Your computer's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
54
Removing and installing components
or
M.2 2280 solid-state
shield.
After working inside your
drive.
computer.
Advertisement
Table of Contents
