Dhcp Settings - TP-Link TL-WA901ND User Manual

Chapter 4
• If you select
• If the new IP address you set is not in the same subnet as the old one, the IP Address pool in the DHCP
Server will be configured automatically.
4. 3. 2.
1. Visit http://tplinkap.net, and log in using
2. Go to
3. Specify DHCP server settings and click Save.
• DHCP Server
DHCP server within your network or else you must configure the computer manually.
• Start IP Address
assigning IP addresses. 192.168.0.100 is the default start address.
• End IP Address
IP addresses. 192.168.0.199 is the default end address.
• Address Lease Time
will be allowed to connect to the access point with the current dynamic IP Address.
When time is up, the user will be automatically assigned a new dynamic IP address.
The range of the time is 1 ~ 2880 minutes. The default value is 120.
• Default Gateway (Optional)
the access point. The default value is 192.168.0.254.
• Default Domain (Optional)
• Primary DNS (Optional)
• Secondary DNS (Optional)
provides two DNS servers.
Note:
• To use the DHCP server function of the access point, you must configure all computers on the LAN as
Obtain an IP Address
Downloaded from ManualsNet.com
Smart IP(DHCP), the DHCP server of the access point will not start up.

DHCP Settings

Network > DHCP Settings.
- Enable or disable the DHCP server. If disabled, you must have another
- Specify an IP address for the DHCP Server to start with when
- Specify an IP address for the DHCP Server to end with when assigning
- The Address Lease Time is the amount of time a network user
- It is suggested to input the IP address of the LAN port of
- Input the domain name of your network.
- Input the DNS IP address provided by your ISP.
- Input the IP address of another DNS server if your ISP
automatically.
search engine
admin (all lowercase) for both username and password.
Configure the Access Point
25