Advertisement
11.1. Procedure for Displaying Error Codes
1. Supply the power.
2. Press [CD
now set to CD mode.)
3. Press (OPEN/CLOSE [
test disc (SZZP1054C), and press [OPEN/CLOSE
close the disc tray. (Cf. Fig. 10)
4. While pressing and holding down [STOP
press the number key on the remote controller, (4) and then (7).
([
] is lit on the FL display.)
5. When the number key, [15] ([
error code appears as a result of automatic adjustment. Error
codes help to detect the faulty parts in the servo circuit. The code
"E-0" means "no faulty operation".
6. Press POWER button to turn off the power (or the unit will remain
in the automatic adjustment display mode). (Cf. Fig. 10)
7. Press POWER button again, and press [OPEN/CLOSE
to remove the test disc. (Fig. 10)
/
] button. (The power is turned on, and the unit is
] button to open the disc tray. Insert the
] button on the unit,
10]
[1]
[5]) is pressed, an
51
] button to
] button
Advertisement
